Jordan Kaufman

“What a wonderful company, David looked after my issues with 4 doors so quickly and professionally I couldn’t be more happy. Total gentleman and the company is responsible and timely with appointments and booking. You can’t go wrong!”
Open
Residential and commercial · Hamilton
We repair residential and commercial doors across Hamilton, assessing support, closing and release hardware while keeping glazing and powered operation clearly scoped.
Leave your details and get $50 off your first repair.
Original customer reviews
Customer reviews
Relevant customer work from across our service area. These reviews are not presented as jobs from this specific city.
Open a review to read the original customer feedback.
Read more customer reviews






















Work at these locations includes jobs through facilities contractors. Logos belong to their owners; no affiliation, sponsorship or endorsement is implied.
Our service
A door that sticks, drags on the floor or will not latch may have a hardware, alignment or frame problem.
We start with the reveal, the gap running around the door, which should stay even from top to bottom. Uneven gaps point to hinge wear, a racked frame or a settled floor. We check hinge screws, jamb plumb and strike position before touching anything, so the repair addresses the cause rather than the symptom.
Loose or worn hinges can make a door stick. We check the hinges, fixings and frame alignment before choosing the repair. Depending on the fault, we secure the fixings, adjust the door or replace damaged hinges.
If a door needs pulling or lifting unexpectedly to lock, we assess its support, latch and strike together. Some multipoint locks require the handle to be lifted as part of normal operation. We identify the mechanism and cause before recommending alignment work or replacement hardware.
Torn or compressed weatherstripping is the usual source of a draft you can feel with your hand. We fit jamb seal in the correct profile for your frame, replace the door sweep, and reset an adjustable threshold so it seals without dragging the sweep to pieces. Rotted sill wood is rebuilt before new seal goes on.
We inspect damaged jambs, frames and door slabs before recommending repair or replacement. The assessment considers the extent of the damage, the condition of the fixing points and any fire rating or security requirements. Reinforcement, patching or adjustment is considered only where suitable for that door and frame; otherwise we explain the replacement scope.
On commercial and multi-unit doors we adjust the closer arm for sweep speed, latch speed and backcheck so the door shuts fully without slamming. Leaking closers are replaced rather than topped up. We also service panic hardware, floor pivots and hold-open arms, and set closing force light enough to stay comfortable to use.
Hamilton's lower city includes older brick homes and rowhouses, while the upper city and mountain areas include postwar and later builds.
Every job starts with a diagnosis and a price you approve before work begins. What moves the number is which hardware failed, whether the part is stocked or has to be matched and ordered, the condition of the frame, and after-hours callouts.
Door repair in Hamilton begins with the installed opening and the people responsible for its use. Describe whether it serves a house, shared hallway, office, shop or an industrial pedestrian passage. Explain which action fails and who can authorize the work. An entrance may involve a mechanical lock, a closer, supporting hardware and a connected entry system. Those components should be identified before a repair is described as a complete solution for the doorway.
Door N Window repairs and replaces doors, windows and glass for residential and commercial properties throughout Hamilton and the GTA. We cover the lower city, the Mountain, Dundas, Ancaster, Stoney Creek and the rest of Hamilton. We are insured and WSIB Covered, with availability 24/7 and same-day service available. Report the actual damage and access conditions when arranging service.
Hamilton's residential building permit requirements identify new, enlarged or relocated door and window openings among work requiring a permit. Keep that proposal separate from correcting hardware in the existing opening. Ask the Building Division about the actual planned alteration before ordering a leaf or frame around new dimensions. A repair enquiry does not establish approval for changes to the wall or supporting construction.
This distinction matters when the repair uncovers another concern. If the frame preparation is damaged, ask what can be corrected within the agreed opening and whether a wider construction proposal is needed. The work description should explain the condition rather than silently expand into an alteration. Keep any relevant drawings with the project coordinator. Existing clearances and photographs help an assessment; they do not replace the design information needed for an enlarged or relocated entrance.
Hamilton's building permits for small businesses discusses a change of business use as a separate permit matter. Its retail and restaurant application checklist also identifies entrances and fire separations, including rated doors. If your doorway work is part of converting a unit for a new business use, bring the wider project brief to the responsible designer and City contact. Repairing movement alone does not determine the requirements for that conversion.
Provide the approved opening information where it exists, particularly for a door associated with a fire separation or escape route. Do not remove a closer, substitute an unidentified leaf or disable latching to make the entrance easier to operate. Describe the installed labels and requirements from an accessible position. We can assess the repair scope, but a general service page is not a certification of the entire building or approval of an unspecified replacement assembly.
A door that takes extra force to close may be rubbing, displaced or meeting resistance in its hardware. Tell us where in the swing that resistance begins and whether the condition changes after the leaf has been open. Stop using an unstable opening rather than repeatedly slam it. The technician needs to consider attachments and supporting preparation as well as the moving component. A loose screw can be a symptom of damaged material rather than the only defect.
For a hollow metal entrance, note visible deformation, corrosion or separation at accessible edges without dismantling the frame. A different replacement hinge may not be suitable for existing preparation. Our commercial steel door and frame guide explains that broader scope. The proposal should identify whether the retained leaf and frame are suitable for repair, which supporting components change and what additional construction work remains outside the agreed service.
Tell us if the leaf swings abruptly, will not close fully or reaches its receiver without latching. A closer problem and a latch problem can occur together, while damaged alignment can affect both. Our door closer repair service covers the closing mechanism. Selection and adjustment need the actual installed arrangement; increasing closing action is not a substitute for correcting a leaf that catches its frame.
For a panic device, explain the observed release problem without altering its preparation or locking arrangement. Our panic bar installation service describes that equipment and replacement planning. Existing hardware, labels and building requirements should be considered before a change is specified. At a working property, involve the responsible building contact so any temporary restriction and alternative access are understood rather than leaving people to improvise around a door fault.
Hamilton's heritage permit guidance encourages repair rather than replacement of original heritage features as a general approach. Ask Heritage staff about the actual property and proposed work before discarding or changing visible entrance details. A replacement that appears similar in a photograph may differ in material, profile or preparation. Confirm the actual designation and proposed change with the City.
Keep any approved requirements available when discussing a damaged leaf or attached hardware. Distinguish a proposal that retains the entrance from one that replaces its visible construction. If another provider handles specialist conservation or surrounding building work, identify that responsibility and the sequence needed for measurement and installation. The practical aim is to prevent an undefined replacement order while the conditions for retaining or changing the existing feature remain unresolved.
An entrance can have broken glass and a separate operating fault. The door glass replacement service addresses the panel and retaining arrangement; the Hamilton storefront glass page covers fixed business frontage. Describe which panel moves and whether the door already worked poorly before the damage. Do not treat glass installation as proof that hinges, closer or release hardware have also been repaired.
If a button or sensor controls the entrance, report unpredictable powered movement and avoid repeated testing. Our automatic door repair service addresses the operator and associated controls. The complete enquiry should distinguish manual support, glazing and powered operation so the agreed assessment covers the right equipment. After work, keep the opening description, completed components and remaining restrictions available. We can help with repair-related insurance claim paperwork, while the insurer determines coverage.
Read project descriptions and original customer feedback about door, window and glass work.
View project descriptionsExplore repair options for doors, windows and glass. Explore our services.
How it works
Call or send the details. Photos are helpful, but optional.
We assess the job on site. You approve the price before paid work starts.
We secure unsafe openings and arrange the agreed repair or installation.
An itemised invoice describing the work.
Door, window and glass work for homes and businesses. Insured, WSIB Covered and available 24/7.
Insurance claims
After a break-in or property damage, we help with paperwork describing the damage and repair.
Coverage and reimbursement depend on your policy and your insurer's approval.
How we help with your claimService areas
Residential and commercial service across Toronto, Peel, York, Durham and Halton, plus Hamilton, Barrie and nearby communities.
FAQ
Local answers first, then the ones that apply everywhere.
We cover the whole municipality, including the lower city, Mountain, Dundas, Ancaster and Stoney Creek, as well as the GTA. Describe the opening and access when booking.
No. Hamilton identifies new, enlarged and relocated openings among work requiring a building permit. Ask the Building Division about your planned alteration before specifying it.
Provide the wider project brief. Hamilton addresses changes of business use separately; a mechanical door repair does not determine the requirements for converting a unit.
Do not remove or disable hardware to compensate for a fault. Explain the installed requirements and have the opening assessed, particularly where it serves a fire separation or escape route.
Not automatically. Supporting material and the installed preparation affect whether a compatible repair is suitable.
Describe abrupt movement, incomplete closing, visible leakage or loose attachments from a safe position. Binding and latching complaints should be reported too.
Yes. Describe the release problem and provide available opening information. Existing equipment and applicable building requirements need consideration before a change is specified.
Consult Hamilton Heritage staff about the property and proposed work. Keep approved requirements available and distinguish retention from replacement before ordering.
Not automatically. Glazing, support, closing and release are separate components. The agreed scope should state which work is included.
Arrange an automatic-door assessment and avoid repeatedly testing unpredictable movement. Report manual and powered symptoms so the correct equipment is considered.
Also in this area
Nearby
If you are on the edge of Hamilton, we cover the municipalities around it too.
Call (647) 643-5837 and describe what is happening, or send a photo through the form.